Inspection and Workmanship Acceptance Levels D Welded Joints D General

(1) These requirements are essential to ensure safe application of the design rules (see 1.4(2)P)

(2) The required quality level for each welded joint shall be obtained from the detail drawings (see 6.2).

(3) Quality levels above Normal are indicated by a 'Fat' number and an arrow.

(4) Where no 'Fat' number exists at a joint it shall be assumed that Normal quality level only is needed.

(5) Where a 'Fat1 number exists at a joint, but with an arrow in one direction only, it shall be assumed that Normal quality level is needed in the other direction.

0 0

Post a comment