1

d2 t

where:

d is the diameter of the pin; d0 is the diameter of the pin hole;

FEd,ser is the design value of the force to be transferred in bearing, under the characteristic load combination for serviceability limit states.

Table 3.10: Design criteria for pin connections

Failure mode

Design requirements

Shear resistance of the pin v,Rd

v,Ed

Bearing resistance of the plate and the pin

If the pin is intended to be replaceable this requirement should also be satisfied._

Bending resistance of the pin

If the pin is intended to be replaceable this requirement should also be satisfied._

Combined shear and bending resistance of the pin

0 0

Post a comment